CARVIN
Sign in
Easy⏱ 10 - 20 min3 steps·Original on iFixit ↗

Thustmaster Ferrari 458 Spider Racing Wheel motherboard Replacement

Use this guide to replace the motherboard of your Thustmaster Ferrari 458 Spider Racing Wheel.

Tools (4)

Step-by-step instructions

Step 1 · photo 1
1
  • Remove the black 10mm using a JIS #1 screw driver.
  • There are 12 screws.
  • Two of the screws are deep inside the device you might need to use a slim screwdriver.
  • In the picture you see a plastic opening tool instead of screw driver because we did not have our screw driver when we were taking the picture.
Step 1 · photo 1
1
  • Using a small plastic opening tool, gently pry up the white connector that connects the USB cable to the board.
  • Cut the black cable as close to the board as possible.
  • Remove the three screws using PH2 screw driver.
Step 2 · photo 1Step 2 · photo 2
2
  • Remove the two 10mm black screws on the top of device using a Hex 2.5mm Key. Only the two outside screws.
  • Gently pull apart both halves of device to access inside.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Guide content belongs to iFixit, license CC BY-NC-SA. Open original

Замена материнской платы Tustmaster Ferrari 458 Spider Racing Wheel — Carvin Garage · Carvin