1
Jack up the zoomer
- Please switch off the engine for all work.
- Jack up the scooter on the main stand.
Replace Honda Zoomer shock absorbers
The stock Honda Zoomer suspension isn't the best. If you keep bottoming out while riding or the shock absorber is completely broken or you want to replace it with a better one, these instructions will help you to remove your shock absorber.
A little tip: The Honda Lead 50 or Lead 80 shock absorber is a very good and inexpensive (used) replacement for the original shock absorber. It's a little better cushioned and just a little longer than the original.
Step-by-step instructions
2
Remove air filter and cover
- Remove the six PH2 Phillips screws securing the air cleaner cover. The screw in the middle holds the air filter itself and can stay on.
- Remove the air filter and cover.
- When assembling, make sure that the seal lies neatly in the groove provided. It falls out very easily.
3
Loosen the air filter box
- Loosen the three screws with a 10 mm wrench. The lower screws are the same length, the upper one, which is screwed in from above, is shorter.
- The hoses can all stay on, the box just has to be loose to get to the screw behind it.
4
remove seat
- Using a wrench, unscrew the six (three on each side) 12mm bolts and remove the seat and base.
- Theoretically, it is enough to loosen the substructure to get to the screw marked in green. I found it easier to take it off completely.
5
Loosen the shock absorber screws
- Loosen the top 14mm shock bolt, but do not remove it yet.
- Loosen the shock's bottom 12mm bolt, but do not remove it yet.
6
rear wheel inferior
- Shim the rear wheel to keep it from lowering once you remove the bolts. Cardboard works just fine.
- If you don't want to change the shock absorber for an original replacement, but for a better one with a different length, remember that your pad is "height adjustable".
- Now completely unscrew the two screws from the previous step.
7
Remove shock absorber
- Notice how one of the cables goes around the shock absorber. You also have to thread in the new shock absorber in the same way.
- Pull the shock out of the lower bracket and down.
- The lower end of the shock absorber is threaded on one side. Make sure that the thread is on the side of the wheel when installing.
Conclusion
Work the steps in reverse order to reassemble your scooter.
Guide content belongs to iFixit, license CC BY-NC-SA. Open original