CARVIN
Moderate25 - 30 minutes10 шагов·Оригинал на iFixit ↗

2003-2007 Honda Accord Headlight Bulb Replacement

The purpose of this guide is to show how to replace the standard headlight bulb of a Honda Accord. This guide is specifically for Accords manufactured in-between 2003 and 2007. Newer or older models may be similar, but not exactly the same. Avoid touching the glass of the headlight bulb as oil and dirt on the glass can hamper its performance and lifespan.

Инструменты (2)

Запчасти (1)

Пошаговая инструкция

Шаг 1 · фото 1Шаг 1 · фото 2
1
  • Enter your vehicle from the driver's side, and locate the hood lever (in the footwell) near the far left side of the vehicle.
Шаг 2 · фото 1Шаг 2 · фото 2
2
  • Pull the hood lever towards you in order to pop the hood of your vehicle.
Шаг 3 · фото 1Шаг 3 · фото 2Шаг 3 · фото 3
3
  • Reach underneath the front middle of the hood to open the hood.
Шаг 4 · фото 1Шаг 4 · фото 2
4
  • Press upwards on the lever on the underside of the hood in order to fully open the hood.
Шаг 5 · фото 1Шаг 5 · фото 2Шаг 5 · фото 3
5
  • Once the hood is lifted, secure the hood by lifting up the hood prop.
Шаг 6 · фото 1Шаг 6 · фото 2
6
  • I attempted to highlight the location of the plug for the bulb as best as possible, so you can at least know what area we are attempting to access.
  • The bright white object is the plug.
Шаг 7 · фото 1Шаг 7 · фото 2Шаг 7 · фото 3
7
  • In order to replace the bulb on the driver's side, we need to remove the battery.
  • Use the adjustable wrench to loosen the two hex nuts located on either side.
  • Don't fully unscrew the nuts holding the mount to the battery.
Шаг 8 · фото 1Шаг 8 · фото 2Шаг 8 · фото 3
8
  • Once you have removed the mount, carefully lift the battery out of the vehicle.
  • The car battery is much heavier than it looks and is very easy to underestimate. Proceed carefully.
Шаг 9 · фото 1Шаг 9 · фото 2Шаг 9 · фото 3
9
  • Grab the plug and twist it counterclockwise to loosen it. It should pop out fairly easily.
  • If it does not come out easily, do not force it. The plastic will break.
  • Attempt to spray the ***compressed air ***in the area of the plug. Sprayed in the crevice where it turns, this should allow it to move easier.
Шаг 10 · фото 1Шаг 10 · фото 2Шаг 10 · фото 3
10
  • Pull the bulb out from the vehicle.
  • Avoid touching the glass of the*** bulb ***as oil and dirt on the glass can hamper its performance and lifespan.

Завершение

To reassemble your device, follow these instructions, starting from step 12, until step 5, in reverse order.

Контент гайда принадлежит iFixit, лицензия CC BY-NC-SA. Открыть оригинал