1
Disassembling the handle
- Flip the controller upside down.
- Using a Phillips #00 screwdriver, remove the five screws holding the controller back cover in place.
Sega Genesis II Controller Teardown
Пошаговая инструкция
2
- Then remove the back cover of the controller, which gives you access to the motherboard of the controller.
- Carefully put back the 5 screws from step 1 as well as the back cover of the controller
3
Disassembling the motherboard
- Remove the motherboard from the controller body, after releasing the rubber part that holds the cable in the controller body
- This gives you access to the button contact pads
4
Dismantling the buttons
- Remove the contact pads
- Then remove the 8 plastic buttons
5
Dismantling the Directional Pad
- In order to disassemble the directional cross, it is necessary to levergentlypreferably with a plastic Spudger, under the 4 retaining tabs.
- Then, push in the central hole with a fine tool (here a screwdriver), in order to undo the assembly
- For reassembly, be careful to put the corrector in front of the slot of the outer part!
Контент гайда принадлежит iFixit, лицензия CC BY-NC-SA. Открыть оригинал