1
Prep
- Gather your spudger and key fob
- Prepare a surface to work on (ensure it's won't damage the piano black exterior coating)
Tesla Model 3 Key Fob Teardown
A teardown of the Tesla M3 Keyfob performed in advance of attempting to model a slimmer housing for it. You can check out how I built a replacement housing for the PCB here:
Model files and instructions are here: https://www.printables.com/model/624527-...
Пошаговая инструкция
2
Battery Cover Removal
- Using a small pry tool, gently press into the small indent near the front of the key fob while pressing up to pop off the battery cover.
- Remove the coin-cell battery type CR2032 by prying upwards in the small recess
- If all you want to do is replace the battery, stop here.
3
Outer Shell Removal
- Using a stiff spudger or other prying tool, pry back the plastic tabs on the top and bottom of the plastic sides (circled in red)
- Take your time here and go slowly so you don't break the clips
4
Top Casing Removal
- Next, pry up the middle shell section using the four tabs at the sides of the case. (outlined in green on the right side)
5
PCB Extraction
- Last but not least, gently pull out the PCB from the top housing
- The coin cell battery holding bracket (circled in orange) can be removed by gently grabbing with [product|IF145-020|tweezers] and lifting straight up
6
That's an un-wrap!
- And just like that you're done!
- A relatively simple teardown. Go forward and put that PCB to good use with a custom fob housing
Контент гайда принадлежит iFixit, лицензия CC BY-NC-SA. Открыть оригинал