CARVIN
Moderate20 - 35 min7 steps·Original on iFixit ↗

2004-2013 BMW 3 Series Inner Taillight Replacement

With time, the elements can cause the plastic housings on your BMW 3 Series E92 to fade or potentially crack, necessitating replacement.

Since the inner taillights function as a two-stage brake light, they must be replaced in order to ensure both the safety of the driver and those around them.

To facilitate an easy replacement process, this guide will showcase how to remove your old inner taillight and replace it by following the guide in reverse.

Since this job requires minimal tools and experience, it should be a more approachable DIY replacement for those new or experienced with vehicles.

Tools (4)

Step-by-step instructions

Step 1 · photo 1Step 1 · photo 2
1
  • Unlock your trunk.
  • This can be done with either the remote or the trunk release button located on the driver's side footwell area.
  • Using the trunk handle, lift the trunk to it's highest position.
Step 2 · photo 1Step 2 · photo 2Step 2 · photo 3
2
  • Using the appropriate trim tool, carefully remove all ten rivets from the trunk liner.
Step 3 · photo 1Step 3 · photo 2Step 3 · photo 3
3
  • Pull on the green tab to release the inner trunk release handle.
  • After this, the trunk liner should be loose.
  • Carefully remove the liner and put it off to the side for later reassembly.
Step 4 · photo 1Step 4 · photo 2Step 4 · photo 3
4
  • Using either a 10 mm socket or an open-end 10 mm wrench, turn the nut counterclockwise to loosen it and remove the bracket that secures the inner taillight.
  • An open-end wrench was used in this guide, however, both tools work for removing the retaining nut.
Step 5 · photo 1Step 5 · photo 2
5
  • From underneath the inner taillight, push the housing with enough upward force to separate it from its socket.
  • Be careful when pushing the housing, as the connector is still attached to the inner taillight.
Step 6 · photo 1Step 6 · photo 2Step 6 · photo 3
6
  • Tilt the inner taillight enough to gain access to the connector on the underside.
  • Firmly press the locking tab in the center of the connector.
  • Pull downwards on the connector to disconnect the inner taillight housing.
Step 7 · photo 1
7
  • Prepare your new taillight for reassembly.
  • Responsibly recycle your old inner taillight if it is no longer functional.

Conclusion

To reassemble the inner taillight, follow these instructions in reverse order.

Guide content belongs to iFixit, license CC BY-NC-SA. Open original

Замена внутреннего заднего фонаря BMW 3 серии 2004-2013 гг. — Carvin Garage · Carvin