CARVIN
Easy10 - 15 minutes9 шагов·Оригинал на iFixit ↗

2011-2017 Audi Q5 Cabin Air Filter Replacement

If the air quality inside your 2011-2017 Audi Q5 has diminished, and you are experiencing unpleasant odours, poor airflow, or increased allergy symptoms, then it's time to replace the cabin air filter.

The cabin air filter helps maintain clean air inside the vehicle by trapping dust, pollen, and other airborne particles. A clogged or old filter can reduce HVAC performance, affecting overall air quality.

This guide will walk you through the steps to replace the cabin air filter located under the glove box. No special tools or advanced knowledge/skills are required but be prepared to apply moderate force when removing the filter housing in Step 4.

Before beginning, ensure the vehicle is parked on a flat surface and completely powered off. If the existing filter shows signs of mold or excessive buildup, consider wearing protective gear (i.e. mask and gloves).

Инструменты (3)

Запчасти (1)

Пошаговая инструкция

Шаг 1 · фото 1Шаг 1 · фото 2
1
  • Place a towel beneath the glovebox on the passenger side of the vehicle.
Шаг 2 · фото 1Шаг 2 · фото 2
2
  • Remove the three plastic screws securing the foam panel underneath the glovebox using your hands.
Шаг 3 · фото 1Шаг 3 · фото 2Шаг 3 · фото 3
3
  • Remove the foam panel, and take note of its orientation.
Шаг 4 · фото 1Шаг 4 · фото 2
4
  • Remove the white filter housing door by sliding it to the right using the built-in handle.
  • Excessive force may be needed.
Шаг 5 · фото 1Шаг 5 · фото 2Шаг 5 · фото 3
5
  • Remove the old filter and clean out any potential debris inside or around the housing.
Шаг 6 · фото 1Шаг 6 · фото 2Шаг 6 · фото 3
6
  • Slide the new cabin air filter into the housing with the slant positioned in the upper right corner.
Шаг 7 · фото 1
7
  • Place the filter housing door back on the slot and slide it to the left until it's properly secured.
Шаг 8 · фото 1Шаг 8 · фото 2Шаг 8 · фото 3
8
  • Reattach the foam panel in the correct orientation.
  • Ensure the screw holes line up with the screw mounts.
Шаг 9 · фото 1Шаг 9 · фото 2
9
  • Secure and fasten the three plastic screws.

Контент гайда принадлежит iFixit, лицензия CC BY-NC-SA. Открыть оригинал