How To Replace the Engine Air Filter In Your 2018–2024 Jeep Wrangler JL (3.6L)

This guide shows how to remove the old engine air filter and install a new one on a 2018–2024 Jeep Wrangler (JL) equipped with the 3.6 L Pentastar V6.

Dirty or clogged air filters can hamper engine performance—replacing it regularly will keep your Jeep running well.

Follow the steps below to access the filter housing, swap the filter, and secure everything back in place.

Step-by-step instructions

Locate the air filter housing

[youtubetimestamp|13|16]Locate the engine air filter housing in the engine bay. It's near the front left corner.

Release the clips

[youtubetimestamp|18|28]Unclip the four clips that secure the top of the air filter housing.

Remove the housing bolts

[youtubetimestamp|29|40]Use a 10 mm socket to remove the two hex bolts holding the housing.

Remove the old air filter

[youtubetimestamp|40|45]Lift the housing cover, pull out the old air filter, and clean out any debris inside the housing.

Install the new air filter

[youtubetimestamp|45|50]Place the new air filter into the housing.

Align the housing properly

[youtubetimestamp|50|57]Make sure the housing is seated in its single correct orientation before fastening.

Reinstall the housing bolts

[youtubetimestamp|57|68]Thread and tighten the two 10 mm hex bolts back into the housing.

Secure the clips

[youtubetimestamp|68|76]Press down on the housing lid and re‑engage the four fasteners.

With the fasteners clipped and bolts tightened, the new air filter is installed and the housing is secure.

Swap didn't go as planned? Ask our Jeep Wrangler JL Answers Community for help.