CARVIN
Moderate25 - 45 min8 steps·Original on iFixit ↗

Nissan 350Z Tail Light Replacement

In this guide, we demonstrate the process of replacing a broken tail light on a Nissan 350Z. The primary function of a taillight is to create visibility for those behind you and signal what actions you are going to perform such as braking, making a turn, and backing up.

Having a broken taillight creates a hazard for others behind you and could lead to being ticketed due to the lack of visibility to your vehicle.

Before you begin the repair, make sure that your car is off and in park.

Tools (3)

Parts (1)

Step-by-step instructions

Step 1 · photo 1
1
  • Unlock and open the trunk.
  • The button is located right above your license plate.
Step 2 · photo 1Step 2 · photo 2
2
  • Look for the 3 bolts that secure the tail light to the car.
  • Attach your 10MM socket to your 1/4 inch ratchet.
Step 3 · photo 1Step 3 · photo 2
3
  • Using your 10MM socket and 1/4 inch ratchet remove the three bolts.
  • Make sure to keep the bolts together and in a safe place.
Step 4 · photo 1
4
  • Hold both ends of the headlight and carefully remove the assembly.
  • You may need to use some force when pulling, as dowel pins secure it to the car.
  • You can flip the tail light over and place it in the tail light cavity so you do not have to hold it.
Step 5 · photo 1Step 5 · photo 2Step 5 · photo 3
5
  • Check the underside of the connector for a square-shaped slot.
  • Insert your flathead screwdriver into the square tab to disconnect the connector.
  • If you are having trouble with this part, try to push the tab ***in*** then ***down***.
Step 6 · photo 1Step 6 · photo 2
6
  • Reconnect the tail light cable connector to the new tail light assembly.
  • Press the connector firmly into the socket to ensure a secure connection.
Step 7 · photo 1
7
  • Align the dowel pins to allow the light assembly to seat itself safely.
Step 8 · photo 1Step 8 · photo 2
8
  • Replace the bolts and use your hand to tighten the bolt just a bit.
  • Use a ratchet with the 10 mm socket to tighten the bolts fully.
  • Avoid overtightening the bolts, as this can make it harder to remove them the next time you need to replace the tail light.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Guide content belongs to iFixit, license CC BY-NC-SA. Open original

Замена задних фонарей Nissan 350Z — Carvin Garage · Carvin