CARVIN
Easy45 minutes6 шагов·Оригинал на iFixit ↗

2009-2014 Nissan Maxima CVT Fluid Change

Инструменты (5)

Запчасти (4)

Пошаговая инструкция

1
  • Drive the car prior to performing the CVT fluid change. The fluid should be warm when it is changed.
  • Park the car on a flat surface. While the car is running, keep your foot on the brakes and move the gear shift through all of gears: P, R, N, D1, D2, D3.
  • Put the car in Park and turn the car off.
2
  • Remove the transmission fluid dipstick.
  • Using a flathead screwdriver, push in the black plastic tab of the dipstick and pull it out.
  • Using a clean rag, wipe the fluid off and then reinsert it. However, '''insert it backwards''' so that it doesn't lock again.
  • Pull the dipstick out again and verify that the fluid mark is at the second notch at the bottom of the dipstick.
  • Keep the dipstick out of the drain hole.
3
  • Move the drain pan underneath the transmission drain pan.
  • Approximately five quarts of CVT fluid will be drained.
  • Use a 00mm socket to remove the drain bolt.
  • '''TIP:''' Use the socket to loosen the bolt and then use your fingers to finish removing the bolt. This will help prevent the fluid from leaking onto the socket wrench.
4
  • Leave the fluid drain for approximately 10-15 minutes.
  • Insert a new crush washer onto the drain bolt.
  • Insert the bolt into the transmission and tighten it with you fingers.
  • Use a torque wrench to tighten the bolt to xx ft/lbs.
5
  • Refill the transmission with CVT fluid. The car typically takes xx quarts of CVT fluid.
  • Insert three quarts of fluid.
  • Insert the dipstick and check the fluid level.
  • Continue to add small amounts of fluid until the dipstick shows that the fluid reaches the second mark from the bottom.
6
  • Reinsert and lock the dipstick.
  • Take the car for a drive. Don't drive too aggressively.

Завершение

To reassemble your device, follow these instructions in reverse order.

Контент гайда принадлежит iFixit, лицензия CC BY-NC-SA. Открыть оригинал