1
- Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
Sega Genesis Motherboard Replacement
Инструменты (1)
- Phillips #1 Screwdriver купить ↗
Пошаговая инструкция
1
- Remove single black screw from the outside of the bottom cover, using a Philips screwdriver.
2
- Flip the Sega Genesis upright.
2
- Using a Philips screwdriver, remove 11 screws securing silver casing.
3
- Gently lift the top casing.
- '''Note: the case will be connected to the main board by LED wires.'''
3
- Remove silver case.
4
- Bend out the LED leads into vertical positions.
4
- Remove single golden screw on motherboard using Philips screwdriver.
- '''Note:''' Push headphone jack to the side.
5
- Slide the LED wire apparatus off the lead pins.
- '''Note: observe which color wire corresponds with which length of pin.'''
5
- Remove two black screws on the left and right sides of the cartridge slot.
6
- Separate the main board from the outer case.
6
- Remove motherboard.
7
- Re-install new motherboard.
Завершение
To reassemble your device, follow these instructions in reverse order.
Контент гайда принадлежит iFixit, лицензия CC BY-NC-SA. Открыть оригинал