CARVIN
Войти
Moderate7 шагов·Оригинал на iFixit ↗

Volvo Throttle Body fix

In this article, we are going to remove the position sensor from the throttle body and clean it.

Инструменты (3)

Пошаговая инструкция

Шаг 1 · фото 1Шаг 1 · фото 2Шаг 1 · фото 3
1

Volvo throttle body servicing

  • Remove the throttle body from the engine. Remove the cover plate by prying up on the edges with a small screwdriver. It is glued down with silicone. Under the cover plate you will see a computer module that is also siliconed in place.
Шаг 2 · фото 1Шаг 2 · фото 2
2
  • Dig the silicone sealer out of the right side to expose the position sensor wire terminals. The terminals are spot welded (yes, WELDED) together to the leads from the computer module. Use small sharp diagonal cutters to separate the terminal leads.
Шаг 3 · фото 1Шаг 3 · фото 2
3
  • The inside of the housing and the position sensor will both have an oily mess. Clean them by spraying with carb spray or contact cleaner.
Шаг 4 · фото 1Шаг 4 · фото 2
4
  • Carefully pry out the metal ring that protects the sliding contacts. You can clean them with some spray cleaner.
Шаг 5 · фото 1
5
  • Reassemble the metal ring. Apply silicone adhesive around the outside edge, then reinstall the sensor into the throttle body.
Шаг 6 · фото 1Шаг 6 · фото 2
6
  • Wrap some wire strands around the terminal ends to help hold them together tightly. Solder the terminals together (but NOT to each other!).
Шаг 7 · фото 1
7
  • Use silicone to reattach the cover plate and to seal up the side access hole. Allow the silicone to set up before reinstalling the throttle body to the engine.

Контент гайда принадлежит iFixit, лицензия CC BY-NC-SA. Открыть оригинал